Example photo of a residential central air conditioner condenser on a concrete pad beside a single-story home

Residential heating & cooling repair

AC Repair in Selmer, TN

Request residential AC repair, heat pump repair or furnace repair from independent local providers serving Selmer and nearby McNairy County.

Request Service

Example photos Connection service. Repairs are done by independent local providers.

Residential AC repair for Selmer homes

AC Repair Selmer connects homeowners in Selmer, TN with independent local providers for air conditioning repair, heat pump repair and furnace repair. Describe the problem once in the Estimate Request form and your request is shared with providers who cover your area.

According to NOAA 1991–2020 normals for the Selmer station, as published on Wikipedia, Selmer averages a July high of 90.3°F and an August high of 89.7°F, with a record of 107°F. January lows average 29.5°F and the record low is −21°F, so most homes here lean on cooling for months and still need dependable heat in winter.

Requests are accepted from Selmer and nearby towns: Selmer 38375, Adamsville 38310, Bethel Springs 38315, Ramer 38367, Stantonville 38379. This is a residential service; commercial systems are not covered.

Is your AC not cooling? Common symptoms

Most air conditioning repair calls in Selmer start with one of a few symptoms: the system runs but the house stays warm, ice forms on the coil, water appears near the indoor unit, airflow is weak or the unit makes unusual noises. Here is what each usually means.

  • AC not cooling or blowing warm air. Check the thermostat setting and the filter first. If the outdoor unit runs but the house stays warm, a refrigerant leak or airflow problem is common; a leak needs repair, not just more refrigerant.
  • Ice on the indoor coil or refrigerant lines. An undercharged system can freeze the evaporator coil. Turn the system off to let it thaw and request service.
  • Water around the indoor unit. A clogged condensate drain is common in humid weather and can overflow.
  • Weak airflow from the vents. A dirty filter, dirty coil or blower problem can restrict airflow and cut efficiency by up to 15%.
  • Clicking, buzzing or a burning smell. Loose or faulty electrical connections can make operation unsafe. Switch the system off and request service.

Sources: U.S. DOE, Common Air Conditioner Problems (archived); ENERGY STAR maintenance checklist.

Heating and cooling repair services

Three residential services can be requested here: air conditioning repair, heat pump repair and furnace repair. Each section below explains the usual problems, what sources such as the Department of Energy and ENERGY STAR say about them, and when to stop and call a professional.

Example photo of a residential AC condenser with its electrical panel open, showing the capacitor and wiring

Example photos

Air conditioning repair in Selmer, TN

Residential AC repair covers central air systems that run without cooling, blow warm air, freeze up or will not start. With July highs near 90°F in Selmer, a failed system is more than an annoyance. Send one request and independent local providers can review the problem.

The most common reason an AC stops cooling is a refrigerant problem. The U.S. Department of Energy notes that low refrigerant means the system was undercharged or has a leak, and that simply adding refrigerant is not a fix: the leak has to be found, repaired, tested and then recharged by a trained technician (U.S. DOE, Common Air Conditioner Problems (archived)).

Airflow is the next suspect. Dirty filters and coils reduce cooling, and replacing a clogged filter can lower AC energy use by 5–15% (DOE Energy Saver 101: Home Cooling). ENERGY STAR adds that airflow problems can cut efficiency by up to 15% and that a clogged condensate drain is a frequent issue in humid weather (ENERGY STAR maintenance checklist).

Other signs worth a professional look include ice on the indoor coil, which an undercharged system can cause, and loose or faulty electrical connections, which ENERGY STAR describes as a safety risk (ENERGY STAR maintenance checklist). If you hear grinding or smell burning, turn the system off before you request service.

Example photo of a residential heat pump outdoor unit with light frost on the coil on a winter morning

Example photos

Heat pump repair in Selmer, TN

A heat pump both cools and heats, so a fault can show up in July or January. Common complaints are a unit that is not heating, not cooling, stuck in defrost or running on auxiliary heat. Independent local providers can diagnose residential heat pumps in the Selmer area.

Light frost on the outdoor coil is normal when temperatures drop below 32°F, and a defrost cycle typically lasts 5–15 minutes. A unit that stays stuck in defrost or becomes covered in ice should be checked by a professional (DOE/CEE air-source heat pump guide).

The Department of Energy lists poor airflow, leaky ducts, incorrect refrigerant charge and miswired auxiliary heat strips as common heat pump issues (DOE: Air-Source Heat Pumps). Frequent use of auxiliary (strip) heat is costly, so it is a reason to have the system checked (DOE/CEE air-source heat pump guide).

HomeAdvisor lists a faulty defrost timer or reversing valve among the causes of a unit that will not defrost, and a thermostat problem, clogged filter, refrigerant leak, blocked outdoor unit or leaky ducts among the causes of a heat pump that is not heating or cooling (HomeAdvisor).

More about heat pump repair in Selmer →

Example photo of a residential furnace in a utility closet with the front panel removed, showing burners and blower

Example photos

Furnace repair in Selmer, TN

Furnace repair covers residential furnaces that will not start, cycle off early or blow cold air. January lows in Selmer average 29.5°F, so a heating failure needs attention. Before you request service, a few simple checks can rule out the easy causes.

A furnace blowing cold air is often a setting rather than a breakdown: if the thermostat fan is set to ON instead of AUTO, the blower keeps running between heating cycles. A dirty filter can make the furnace overheat and trip its high-limit switch, and a dirty flame sensor or ignition problem can stop the burners from staying lit.

ENERGY STAR warns that a cracked heat exchanger or dirty burner can make a furnace operate unsafely, which is why annual heating check-ups in the fall are recommended (ENERGY STAR maintenance checklist). If you smell gas, leave the home and contact your gas utility.

Typical furnace repair parts named by HomeAdvisor include the flame sensor and the ignitor; national price ranges for both are shown in the cost table below (HomeAdvisor).

More about furnace repair in Selmer →

How much does AC repair cost in Selmer?

No verified Selmer prices exist, so this site publishes only the national ranges reported by HomeAdvisor. AC repair runs $172–$664 nationally, heat pump repair $161–$661 and furnace repair $133–$505. Your quote depends on the diagnosis, parts and labor (source: HomeAdvisor).

National repair cost ranges (HomeAdvisor, updated June 2026) — not Selmer quotes
RepairNational rangeNational averageCommon parts and feesSource
AC repair$172–$664$417Service call $75–$200; capacitor $120–$475; refrigerant leak repair $225–$1,600; compressor $1,200–$2,800HomeAdvisor
Heat pump repair$161–$661$410Won't defrost $90–$650; capacitor $150–$250; defrost control board $200–$650HomeAdvisor
Furnace repair$133–$505$318Flame sensor $150–$250; ignitor $150–$500; labor $50–$150 per hourHomeAdvisor

National averages reported by HomeAdvisor; local prices vary. This site sets no prices; independent providers quote after inspecting your system.

How it works, step by step

You check that your home is in the area, send an Estimate Request, and with your consent it is shared with independent local providers. A provider may contact you, inspect the system and give a written quote. You decide whether to hire anyone.

  1. Check your area

    Make sure your home is in Selmer, Adamsville, Bethel Springs, Ramer, Stantonville or nearby McNairy County. The service is for residential systems only.

  2. Describe the problem

    Use the Estimate Request form: tell us the equipment (AC, heat pump or furnace), what it is doing and your ZIP code.

  3. Your request is shared

    With your consent, the request is passed to independent local service providers who cover your area.

  4. A provider contacts you

    A provider may call or email to ask questions and arrange a visit. Availability is not guaranteed.

  5. Diagnosis and written quote

    The provider inspects the system and explains the repair and price. Ask for the quote in writing.

  6. You decide

    You are never obliged to hire anyone. Verify license and insurance before work starts.

More about how this connection service works →

Homeowner tips before you hire

Before you sign anything, check the provider’s license and insurance, ask for a written quote and know where to turn if something goes wrong. Tennessee sets a state license threshold for HVAC work, and the Attorney General handles consumer complaints.

Licensing. In Tennessee a state contractor license is required to bid or contract HVAC projects of $25,000 or more, including materials, equipment and labor; the HVAC classification is CMC-C (TN Board for Licensing Contractors; TN classification outline). Below $25,000, HVAC work is regulated locally: some jurisdictions issue their own mechanical license, and where the State Fire Marshal inspects, an LLE or CMC-C license is needed for permits (TN Commerce: HVAC projects under $25,000).

Complaints. Contact the business first. If that does not resolve it, the TN Attorney General, Division of Consumer Affairs can be reached at 615-741-4737, or 800-342-8385 from inside Tennessee.

Maintenance. ENERGY STAR recommends checking filters monthly and a pre-season check-up each year: cooling in spring, heating in fall (ENERGY STAR maintenance checklist).

Request Service

Tell us your name, phone, email, town or ZIP and which equipment needs attention. Your request goes to Silvano Para, the operator of this site, and with your consent to independent local providers who may contact you about a residential repair.

Requests are accepted from Selmer 38375, Adamsville 38310, Bethel Springs 38315, Ramer 38367, Stantonville 38379.

Estimate request for residential heating and cooling repair. Independent providers set any price after inspecting your system.

Submitting a request does not confirm an appointment, a price or acceptance of the job. Residential properties only.

AC, heat pump and furnace FAQ

Answers to common questions from Selmer homeowners: filters, maintenance timing, refrigerant, heat pump frost and aux heat, national repair costs, system lifespan, repair or replace, Tennessee licensing and where to file a complaint. Each answer cites its source.

How often should I change my HVAC filter?

ENERGY STAR recommends inspecting the filter every month and changing or cleaning it when it is dirty (ENERGY STAR maintenance checklist). For ducted heat pumps, a DOE/CEE guide notes manufacturers often suggest about every 90 days (DOE/CEE air-source heat pump guide).

When should my system be serviced?

ENERGY STAR recommends a pre-season check-up every year: the cooling system in spring and the heating system in fall (ENERGY STAR maintenance checklist).

Can I just add refrigerant to my AC?

No. The Department of Energy explains that low refrigerant means an undercharge or a leak; the leak must be repaired, tested and the system recharged by a trained technician (U.S. DOE, Common Air Conditioner Problems (archived)).

Is ice on my heat pump in winter normal?

Light frost below 32°F is normal and a defrost cycle typically lasts 5–15 minutes. If the unit stays iced or stuck in defrost, have it checked (DOE/CEE air-source heat pump guide).

Why is my heat pump using aux heat?

Auxiliary heat supplements the heat pump during defrost and very cold weather. Frequent use is costly, so have the system checked if it runs often (DOE/CEE air-source heat pump guide).

How much does AC repair cost?

HomeAdvisor reports a national range of $172–$664 for AC repair, with an average of $417. These are national figures, not Selmer quotes; local prices vary (HomeAdvisor).

How long does a central air conditioner last?

The Department of Energy puts the typical life of a central air conditioner at about 12–15 years (DOE Energy Saver 101: Home Cooling).

Should I repair or replace my system?

A HomeAdvisor rule of thumb is to consider replacement when the repair would cost more than half the price of a new unit, or the unit is over 10 years old (HomeAdvisor).

Does an HVAC contractor need a state license in Tennessee?

A state contractor license is required for projects of $25,000 or more; the HVAC classification is CMC-C (TN Board for Licensing Contractors). Smaller jobs are regulated locally (TN Commerce: HVAC projects under $25,000).

Where can I file a complaint about a contractor?

Contact the business first. You can then reach the TN Attorney General, Division of Consumer Affairs: 615-741-4737, or 800-342-8385 from inside Tennessee.